Tip:
1. The normal operating voltage of the speaker is 9-16V.
2. The horn should be installed away from the engine.
3. It is better to install the horn with the mouth 45° slanted downward, which is more waterproof.
4. Don’t press and hold the horn for a long time, preferably no more than 30 seconds.
The Following Problems May Occur When The Horn is Working Erratically:
1. The copper terminals of the wiring have signs of loosening or falling off.
2. The battery does not have enough power.
3. The connection wire of the horn is too thin.
4. The horn button is damaged.
peter p. –
These horns make a great replacement for any vehicle with a duel horn setup. the fit rite onto the original mount of my 2014 ford focus titanium hatchback. install was a breeze, I clipped the OEM plug added female spade connectors and a jumper wire to connect both horns. from that point they are just plug and play. Very loud and has a pleasant sound. Although they sound nothing like a train horn. lmao!
Cory Dilts –
With both horns it isn’t much loader than a regulars car horn. I work at a rail road it wasn’t even close to what they advertise. expected something better than a car horn. They do work great easy to install but not very load. Very disappointed.
Emm Kay –
NOT train-like sound – NOT 300db. Seller should tell the truth.Regardless, acceptable sound, not much better then the OEM horn on my 2000 Toyota Tundra.Installation was confusing to me due to a single terminal connection on the original horn and 2 terminals on this product. I took a chance and grounded the 2nd terminal to the installation bolt and it worked. I’m not an auto electronics expert, so user discretion is advised for this method.
Ramiro Gonzalez –
Very high nois
Stephen A Warren –
Not NEARLY as loud and manly as I’d hoped it would be. honestly kind of embarrassed every time I honk it. But. It is a horn. And the shrill sound definitely gets attention. But. I’ll be replacing it with something a little more manly. Like a Train horn… 🙂 Fairly difficult to install for folks with manly hands. Lost two nuts in the process. Never found them. Recommend removing as much stuff as you can from around the horn before attempting the install. And be careful about which wire attaches where. It’s not as intuitive as you’d think (i.e. the connectors look just the same… you’d think they’d make one larger than the other or make a bracket that fits only one way… but no).
Randy Flores –
They work great you can hear them, but they’re not loud like a train. I would not recommend this.
M –
Wanted to get a louder horn for my bike. This was a good price and easy to install. I’m sure there are better ones out there, but for the price you can’t beat them.
Stephani R. –
Super waste not loud, not super, they work but they aren’t that super.